AIRFLOW PERFORMANCE BOOST PUMP HOW TO

The pump should now be active, you should be able to hear the mechanism rotating when an outlet is opened. Once you have ensured all air is purged from the system, checked for natural flow on the cold outlets, and inspect for any leaks, you can now plug in the the pump or connect it to a fused spur. This will ensure that the air has been discharged from the connecting pipe work and pump chamber. It is critical to discharge water through all the outlets, using natural flow before switching the pump on electrically. With the pump installed, you will then need to open the isolation valves, checking for any leaks as you go.įlush the inlet pipework and fully fill the pump with water by opening all the water outlets before electrically switching the pump on. You can now switch the mains water back on at the stop tap. Now, you can introduce the pump into its location and gently connect it to the pipework. These pumps require 15mm or 22mm isolation pump connections, along with an outlet flat washer and inlet filter washer.( Fittings kit available separately.) 4. You must ensure the size of this section at least exceeds the height of the pump (this can be found on the HomeBoost or CombiBoost pages, allowing enough space for both the pump and required fittings. Next, cut and remove the required section of the pipe. Make sure to turn off the mains water supply at the stop tap and drain down the system.

AIRFLOW PERFORMANCE BOOST PUMP HOW TO

You can now begin to install the pump, here’s how to do it in eight steps….

Installationīegin your installation by unboxing the pump and reading the installation guide, this is key to avoiding common installation pitfalls. Ensuring there is adequate airflow to cool the motor, and ensuring that it is separated from any other appliances that generate heat. It is advised to position the pump near the stop tap, installing either vertically or horizontally, but never upside down. The pump should be fitted directly into the incoming mains supply either just after the stop-tap or just before the combination boiler. This is your first port of call and should be reviewed for each install. Boost your fuel delivery systems efficiency and performance with our universal inline fuel pumps. Before beginning the installation process, you should always read the installation guide.

Airflow performance boost pump